glass transition raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
Reviewed 2026-05-10. Anything still debated is marked as such rather than presented as settled.
Stability of a lyophilized solid depends on water content, temperature, and the physical state of the formulation. Amorphous products may slowly absorb moisture and drop below their glass transition temperature, causing collapse or crystallization. Some proteins and peptides can aggregate even in a dry state, especially when exposed to heat or moisture. Accelerated stability studies at elevated temperature and humidity help estimate shelf life, but real-time data remain the basis for expiration dating.
After drying, a lyophilized product is usually sealed under vacuum or an inert gas to limit moisture and oxygen exposure. The container closure system matters because stoppers and seals can allow moisture ingress over time. Storage conditions are selected from stability studies that track potency, cake appearance, and reconstitution behavior. Many freeze-dried materials are kept at controlled room temperature, while some require refrigeration or protection from light.
Quality control for freeze-dried forms includes visual inspection, water content measurement, and reconstitution time. A satisfactory cake is typically uniform, porous, and intact, although minor shrinkage or cracking may be acceptable if specifications allow. Karl Fischer titration, thermal gravimetric analysis, and near-infrared spectroscopy are used to measure water content. Reconstitution is assessed by adding a specified diluent and recording the time and ease of dissolution. Microbiological and particulate tests are added when the product is sterile or intended for injection.
After primary drying, secondary drying removes water that remains bound to the material. This stage raises the shelf temperature while maintaining low pressure, which encourages desorption of unfrozen water. Residual moisture can be reduced to a low percentage, improving stability for many products. The process parameters, including freezing rate, shelf temperature, and chamber pressure, influence the final pore structure and reconstitution behavior. Control of these variables helps prevent collapse or meltback during drying.
A formulation often contains excipients that protect the active ingredient during freezing and drying. Bulking agents provide structure, while lyoprotectants stabilize sensitive molecules. The freezing step can produce ice crystals whose size and distribution affect the drying rate, and cycle design includes freezing, annealing, and drying phases. If the product temperature rises above a critical value, the cake may collapse or lose its porous structure. Successful lyophilization therefore depends on the interaction between formulation, equipment, and cycle design.
| Property | Value | Notes |
|---|---|---|
| Appearance | Porous cake or plug | Uniform structure suggests the drying cycle preserved the matrix. |
| Reconstitution time | Usually under 2 minutes | Depends on cake porosity, diluent volume, and excipient composition. |
| Water content range | 0.5–3% w/w | Common specification range; exact limits are product-specific. |
| Headspace oxygen | <1% v/v | Inert gas backfill reduces oxidation of sensitive materials. |
| Storage temperature | 2–8 °C or controlled room temperature | Choice depends on accelerated and real-time stability results. |
Residual moisture is a key quality attribute for lyophilized products. Water that remains after secondary drying can affect chemical stability, cake structure, and shelf life. Karl Fischer titration is a common method for measuring water content in the dried solid. The target range varies by product, but many biologics are dried to between 0.5% and 3% water by weight. Acceptable limits are set during development and confirmed by stability studies.
Stability studies examine how temperature, humidity, and time influence a lyophilized product. Accelerated conditions provide early information about degradation pathways, while long-term studies support shelf-life claims. The glass transition temperature of the dried formulation can indicate its physical stability, and storage above this temperature may increase molecular mobility and lead to collapse or aggregation. Container closure integrity also matters because moisture or oxygen ingress can degrade the product, so vial stoppers and seals are part of the quality system.
A typical cycle begins with freezing, which fixes the material into a solid and determines ice crystal size. Primary drying then raises heat under vacuum so ice sublimes, often near or below the collapse temperature of the formulation. Secondary drying removes bound water that remains after ice is gone, usually by gently warming the product. Each stage balances heat input against pressure to avoid melting or structural damage. Temperature probes and pressure sensors guide the transition between stages.
In practice, lyophilization is slower and more energy intensive than simple drying. Cycle times can range from hours to several days depending on load, container, and formulation. Amorphous materials may require excipients that help preserve structure during freezing and drying. The method is widely used for biological materials, pharmaceuticals, and foods where heat drying would cause unacceptable change. Open questions remain about scaling cycles between laboratory and production equipment, and this gap affects technology transfer.
Lyophilization removes water by freezing a material and then lowering pressure so ice changes directly to vapor. The process relies on sublimation, the phase transition from solid to gas without an intermediate liquid state. Because the material remains frozen during primary drying, the structure often stays porous. This porous matrix can rehydrate quickly when water is added back. The low pressure also allows vapor to leave the solid matrix without boiling.
==== Opioids ==== The use of opioids is controversial. As of 2015, no opioid is approved for use in this condition by the FDA. A 2016 Cochrane review concluded that there is no good evidence to support or refute the suggestion that oxycodone, alone or in combination with naloxone, reduces pain in fibromyalgia. The National Institute of Arthritis and Musculoskeletal and Skin Diseases (NIAMS) in 2014 stated that there was a lack of evidence for opioids for most people. The Association of the Scientific Medical Societies in Germany in 2012 made no recommendation either for or against the use of weak opioids because of the limited amount of scientific research addressing their use in the treatment of fibromyalgia. They strongly advise against using strong opioids. The Canadian Pain Society in 2012 said that opioids, starting with a weak opioid like tramadol, can be tried but only for people with moderate to severe pain that is not well-controlled by non-opioid painkillers. They discourage the use of strong opioids and only recommend using them while they continue to provide improved pain and functioning. Healthcare providers should monitor people on opioids for ongoing effectiveness, side effects, and possible unwanted drug behaviors. A 2015 review found fair evidence to support tramadol use if other medications do not work. A 2018 review found little evidence to support the combination of paracetamol (acetaminophen) and tramadol over a single medication.
==== History ==== Initially the countercurrent exchange mechanism and its properties were proposed in 1951 by professor Werner Kuhn and two of his former students who called the mechanism found in the loop of Henle in mammalian kidneys a Countercurrent multiplier and confirmed by laboratory findings in 1958 by Professor Carl W. Gottschalk. The theory was acknowledged a year later after a meticulous study showed that there is almost no osmotic difference between liquids on both sides of nephrons. Homer Smith, a considerable contemporary authority on renal physiology, opposed the model countercurrent concentration for 8 years, until conceding ground in 1959. Ever since, many similar mechanisms have been found in biologic systems, the most notable of these: the rete mirabile in fish.
(1978), federal judge of the United States District Court for the District of New Jersey Rolando Acosta (1979), associate justice of the Appellate Division of the New York Supreme Court, First Judicial Department Frank J. Aquila (1979), corporate lawyer, partner at Sullivan & Cromwell Umar Ata Bandial (1979), justice of the Supreme Court of Pakistan and former chief justice of Lahore High Court Lanny A. Breuer (1980), U.S. assistant attorney general for the Criminal Division Ronald Weich (1980), U.S. assistant attorney general for the Office of Legislative Affairs Paul Feinman (1981), judge of the New York Court of Appeals Michael H. Cohen (1983), healthcare law attorney, professor at Harvard Medical School Miguel Estrada (1983), controversial nominee to the United States Court of Appeals for the D.C. Circuit Steven Reich (1983), CEO of Deutsche Bank Trust Company and former associate deputy attorney general 2011–2013 Gary R. Brown (1985), judge of the United States District Court for the Eastern District of New York John H. Chun (1991), judge and nominee to the United States District Court for the Western District of Washington Andrew Ceresney (1993), chair of litigation practice at Debevoise & Plimpton and former head of enforcement at the U.S. Securities and Exchange Commission Veronica S.
The Orange Book, formally titled Compendium of Analytical Nomenclature, contains internationally accepted definitions for terms in analytical chemistry. It has traditionally been published in an orange cover. Although the book is described as the "Definitive Rules", there have been three editions published; the first in 1978 (ISBN 0-08022-008-8), the second in 1987 (ISBN 0-63201-907-7) and the third in 1998 (ISBN 0-86542-615-5). The third edition is also available online. A Catalan translation has also been published (1987, ISBN 84-7283-121-3).
Sources: en.wikipedia.org
=== Names === Selegiline is the generic name of the drug and its INNTooltip International Nonproprietary Name, BANTooltip British Approved Name, and DCFTooltip Dénomination Commune Française, while selegiline hydrochloride is the USANTooltip United States Adopted Name. The word "selegiline" is pronounced (sə-LEJ-i-leen) or as "seh-LEH-ji-leen". Selegiline is also known as L-deprenyl, L-deprenil, L-deprenalin, L-deprenaline, L-phenylisopropylmethylpropinylamine, and L-E-250. It should not be confused with the racemic form, deprenyl (E-250), or with the dextrorotatory enantiomer, D-deprenyl, which are distinct substances. Major brand names of selegiline include Eldepryl, Jumex, and Movergan (oral tablet and/or capsule), Zelapar (orally disintegrating tablet or ODT), and Emsam (transdermal patch). Selegiline has been marketed under more than 70 brand names worldwide. The brand name "Emsam" was derived from the names of two children, Emily and Samuel, of one of the executives at Somerset Pharmaceuticals, the developer of Emsam.
24 May – Researchers from the Chinese Academy of Sciences report tuning of the Casimir effect using magnetic fields. 30 May – NASA reports that the James Webb Space Telescope has discovered JADES-GS-z14-0, the most distant known galaxy, which existed only 290 million years after the Big Bang. Its redshift of 14.32 exceeds the previous record of 13.2, set by JADES-GS-z13-0. 31 May – Biologists report that Tmesipteris oblanceolata, a fern ally plant, was found to contain the largest known genome. Promising results of health and medical research are reported: a mRNA vaccine-like immunotherapy against brain cancer tested in a preliminary small trial (1 May), ferrets-tested mRNA vaccine against the clade 2.3.4.4b H5 bird flu amid concerning developments of the 2020–2025 H5N1 outbreak (23 May), mice-tested antibiotic lolamicin specific to Gram-negative bacteria that spares the gut microbiome (29 May).
== Further reading == Gadd GM, Griffiths AJ (1 December 1977). "Microorganisms and heavy metal toxicity". Microbial Ecology. 4 (4): 303–317. Bibcode:1977MicEc...4..303G. doi:10.1007/BF02013274. ISSN 1432-184X. PMID 24232222. Some microbes tolerate metals that would be toxic to humans.
Sources: en.wikipedia.org
Sealed vials or containers should be kept at the temperature specified by stability data, often controlled room temperature or 2–8 °C. Moisture and oxygen barriers are important because both can degrade sensitive materials. Opened containers may need immediate use or protection from ambient humidity.
It usually appears as a uniform porous plug or cake that fills the container without excessive shrinkage. Color should match the specification, and there should be no meltback or visible foreign matter. Minor cracking may be acceptable if the product still meets moisture and potency limits.
Water content is a key stability parameter because excess water can promote hydrolysis, aggregation, or cake collapse. It also affects reconstitution and product weight. Each product has a target range, and methods such as Karl Fischer titration are used to verify it.
Lyophilization removes water by sublimation from a frozen material, while evaporation changes liquid water into vapor. The low-pressure freezing step avoids the liquid phase and can preserve heat-sensitive structures.